In the field of health products, daily maintenance and maintenance skills of tablet press molds Industry data shows that the sales of China's health care products in the mainland market increased from 44.2 billion yuan in 2012 to 237.6 billion yuan in 2017. It is estimated that the size of the mainland's health care product market will exceed 300 billion yuan in 2021. It can be seen that the sales of domestic health care products continue to increase, and the market situation in the future is optimistic, which will also indirectly drive the development of China's health care product manufacturing and processing equipment market. Among them, the tablet press belongs to a kind of health care product processing equipment, and is suitable for tablet-shaped health care product compression molding. According to the industry, in the production process of tablet-like health products, tablet press molds play a vital role in product quality. For example, the punch holes become larger, causing uneven punching fillers, which may result in discrepancies in product sheet weights or cracks; the length of punches may directly affect product discrepancies and hardness, causing cracks, or brittleness; punches There are curled edges, or the punch is not flat, which affects the one-sided surface and causes chipping and sticking. Therefore, the mold needs to be inspected and repaired or replaced as necessary before use to ensure the stability of product quality and continuous tablet production, reducing the cost of the enterprise. In addition, after the tablet press mold is installed and used, it is also necessary to carry out inspection and maintenance to ensure that the equipment is intact the next time the company uses it. Therefore, in daily management, operators must pay attention to the daily maintenance, maintenance and storage of tablet press molds to ensure product quality. In this regard, some staff of tablet press equipment manufacturers shared the daily maintenance and maintenance skills of tablet press molds, which are mainly divided into five points for industry reference only. First, if a health care product manufacturer purchases a new tablet press mold, the tablet press mold needs to be accepted and accepted by the workshop mechanic. After passing the test, the tablet team leader will confirm it again. Under the condition of ensuring the stable operation of the equipment, it can be put into production. Secondly, it is necessary to pay attention to the storage of the equipment. After receiving, the workshop mechanics need to remove the outer packaging. After removing the rust-proof oil, use 95% ethanol for cleaning and disinfection before storing in the mold room for storage. Model and film placement area, with obvious signs. Third, before using the tablet press mold, check whether the specifications and models of the tablet press molds for health products are consistent with the required models. Before the mold is installed, wipe it with a clean cloth, and then wipe it with 75% ethanol. After the ethanol has evaporated, use the machine again. The industry reminds that during the installation process, pay attention to check whether the punch and die match, pay attention to handling, and at the same time, do not mix the old and new molds. You must evaluate or test the control and impact on the difference in sheet weight when you have to mix. Fourth, the molds of the tablet press for health products should be returned to the mold management room and cleaned in time after use. Use 95% ethanol when cleaning. During the cleaning process, pay attention to check the mold for damage, pick out any damage in time, and repair it for repair. If the repair cannot be performed, the workshop mechanic will evaluate the scrap and register it. Fifth, if the cleaned mold is not used for a long time, it should be coated with a layer of anti-rust oil. When storing, the mold should be placed in the area according to the model and sheet type. At the same time, it should be clearly marked. The industry recommends that the temperature and humidity of the room should be ensured during the storage process to avoid the rust of the tablet press machine for health products. If the humidity of the room is too high, you can turn on the dehumidifier to keep it dry and keep the mold room clean and dry. Anything.
